Fault Codes / Dixell

15 codes

Universal-XR / XR75CX / XR160D / XR170D

• EE — Data or memory (EEPROM) failure — the internal watchdog has detected a failure in data or in the internal memory of the controller.

XR06CX / XR60CX

• CA — Serious external alarm (digital input) — control may stop.
• dA — Door alarm — door open too long.
• EA — External alarm (digital input).
• HA — High temperature alarm (too warm).
• LA — Low temperature alarm (too cold).
• LA2 — Condenser low temperature alarm.
• P1 — Thermostat probe (Probe 1) fault or wrong probe type (NTC/PTC).
• P2 — Evaporator probe (Probe 2) fault — defrost control affected.
• P4 — Fourth probe failure.

XR160D / XR170D (i1F/i2F dijital giriş yapılandırması)

• BAL — Serious external alarm via the configurable digital input (i1F/i2F = bAL) — all relay outputs are switched OFF; on XR160D/XR170D the raw code is displayed as "BAL" (the equivalent alarm is collapsed to "CA" on other Dixell models).
• EAL — Generic (non-serious) external alarm via the configurable digital input (i1F/i2F = EAL) — on XR160D/XR170D the raw code is displayed literally as "EAL" (not abbreviated to "EA" as on XR60CX/XR06CX).
• PAL — Pressure switch alarm via the configurable digital input (i1F/i2F = PAL) — the compressor and regulation are stopped; on XR160D/XR170D the raw code is displayed as "PAL" (the equivalent alarm is collapsed to "CA" on other Dixell models).

XR60CX

• HA2 — Condenser high-temp alarm (if Pb3 set as condenser).
• P3 — Third probe (Probe 3) fault (e.g. condenser/product).