Samsung E652

Low

DVM PLUS III — Two wired remote controllers were set to the master mode.

Samsung E652: Two wired remote controllers were set to the master mode. This fault is usually minor, but points to an underlying cause.

Possible causes

DIP switch/menu setting on both controllers identically set to master.
Setting not reset after replacing one remote controller.

Check steps

Check master/slave setting on both remote controllers.
Switch one remote controller to slave and restart the system.

Affected parts

Kablolu uzaktan kumanda (MWR-WS00)

Safety note

De-energize before servicing.

Source: Samsung resmi servis kilavuzu (bagimsiz cift-dogrulandi) — Samsung DVM PLUS III Technical Data Book, ManualsLib s.61 — "E-652: Two wired remote controllers were set to the master mode. (COM 1 wiring)". Önerilen Almanca anlam doğru ama "(COM 1 wiring)" kısmını eksik bırakıyor; tam çeviri: "Zwei Kabelfernbedienungen wurden beide auf Master-Modus eingestellt (COM 1-Verkabelu…

Reviewed by Anıl Güzeldemir — in the refrigeration machine room since 2006, developer of Enthalio.

Look up in Enthalio →

Related fault codes

Heating operation prohibited because ambient tE440 Indoor unit's address setting error on theE215 Installed indoor unit count exceeds the MCU seE218 Oil balance temperature sensor malfunction.E307 Reverse phase or phase open (3-phase wiring ofE425 Overload error of outdoor unit's motor (byE453